Configure Cisco RV325 for VoIP

Configure Cisco RV325 for VoIP

The default firewall settings on Cisco routers have SIP ALG and SPI (Stateful Packet Inspection) enabled, which can cause issues with cloud based VoIP. 
​

Firewall Configuration

  1. Go to System Summary and ensure that the firmware is up to date (1.1.1.06 or later).
  2. If needed, update firmware by going to System Management > Firmware Upgrade.
  3. Go to Firewall > General.
  4. Ensure that Firewall and Remote Management are enabled (checked).
  5. Ensure that the following are disabled (unchecked):
    • SPI (Stateful Packet Inspection)
    • DoS (Denial of Service)
    • Block WAN Request
    • SIP ALG
  6. Click Save.
  7. Browse to IPADDRESS/f_general_hidden.htm.
  8. Set UDP Timeout to 300 seconds.
  9. Save all changes.

    • Related Articles

    • SonicWall firewall VoIP configuration

      The default firewall settings on SonicWall firewalls may cause issues with VentureTel VoIP traffic.  Some issues you may see are: Problems with phone registrations Dropped calls Phones not ringing One-way audio The TZ400 is an exception to this ...

    • Configuring Dell Sonic Wall for VentureTel VoIP

      Step 1: Go to VoIP > Settings.  Step 2: Check Enable Consistent NAT, uncheck/disable everything else. Step 3: Click  Accept to save the settings.

    • VoIP Phone Troubleshooting - Start with a Reboot

      Problem Are you experiencing issues with your VentureTel.net VoIP phone service? It might be something as simple as needing to reboot your phone. Solution Often, a quick reboot of your VoIP phone can resolve minor glitches that may be causing issues ...

    • Adjusting Netgear Routers to Support VoIP

      Netgear ships their routers so that out of the box they rewrite SIP (VoIP) packets due to their stateful packet inspection (SPI) firewall & SIP ALG.  However, Netgerrs implementation of the SPI firewall and SIP ALG breaks the connection between VoIP ...

    • Manually configure Zoiper soft phone on mobile

      To manually configure the Zoiper soft phone on your mobile device, start by creating a new soft phone device in the  control panel  and attach it to the appropriate user account. You'll need the SIP Username, SIP Password of the device and Realm for ...